|
Silicone Gasket Maker
- Makes Leak-Proof Gaskets Instantly
- Resists Temperatures up to 500oF (260oC)
- Resists Cracking, Shrinking, and Migration Caused By Thermal Cycling
- Seals Timing Chain Covers, Water Pumps, Valve Covers, Etc.
- Fast Curing, Remains Flexible
- Resists Oil, Water, Antifreeze, and Transmission Fluid
INSTRUCTIONS FOR USE Clean all surfaces thoroughly. Remove old gaskets and prepare flange surfaces. Dry and remove oil and grease. Remove cap, puncture inner seal, screw on nozzle and cut to desired size. Apply continuous, uniform beads around perimeter of one surface. Completely surround all bolt holes. Wait 10 minutes for Silicone to "skin over". Reassemble parts. Note: Leave thickness for Gasket when reassembling. Do not over-tighten bolts. Silicone dries to touch in 1 hour. Allow 24 hours to fully cure and bond. Replace the cap after use. Special Properties May be applied overhead or on side wall joints. Will not sag or run-off. PACKAGING / STORAGE
- 3-ounce (85 g) Carded Tubes / 12 Tubes per Case
- Available in Blue (Part No. 10-AB), Black (Part No. 12-AB), and Clear (Part No. 13-AB)
- Storage: Keep Container Closed and Store Away From Water or Moisture
COMMENTS: Acetic Acid is formed upon contact with water or humid air. Provide adequate ventilation to control exposure. Technical Data
|
Physical Form
|
Paste (blue, black or clear)
|
|
Odor
|
Acetic Acid Odor / Oxime
|
|
Specific Gravity @25oC
|
1.03-1.38
|
|
Solubility in Water
|
<0.1
|
|
Boiling Point
|
N/A
|
|
Chemical Stability
|
Stable
|
|
Flash Point
|
N/A-Solid
|
|
Ignitable
|
N/A
|
|
Corrosive
|
N/A
|
|
Reactive
|
N/A
|
|
Extension Rate: (3.18 mm orifice GI min)
|
400
|
|
Track Free Time: 256 (77 F)
|
10-20 minutes
|
|
Cure Time: 25C (77F)
|
24 hours
|
|
