|
Red Silicone Gasket Maker
ABRO Red Silicone Gasket Maker
- Makes Leak-Proof Gaskets Instantly - Sensor Safe
- High Temperature - Resists Temperatures up to 650oF (343oC)
- Ideally Suited for Intake and Exhaust Manifolds, Headers, Thermostat Housings, etc.
INSTRUCTIONS FOR USE
Clean all surfaces thoroughly. Remove old gaskets and prepare flange surfaces. Dry and remove oil and grease. Remove cap, puncture inner seal, screw on nozzle and cut to desired size. Apply continuous, uniform beads around perimeter of one surface. Completely surround all bolt holes. Wait 10 minutes for Silicone to "skin over". Reassemble parts.
Note: Leave thickness for Gasket when reassembling. Do not over-tighten bolts. Silicone dries to touch in 1 hour. Allow 24 hours to fully cure and bond. Replace the cap after use.
Special Properties
- May be applied overhead or on sidewall joints.
- Will not sag or run-off.
PACKAGING / STORAGE
- 3-ounce (85 g) Carded Tubes / 12 per Case
- New Size 1.5-ounce (42.5 g) Carded Tubes / 12 per Case
- No Special Handling Precautions
- Storage: Keep Container Closed Store Away From Water or Moisture
COMMENTS: Acetic Acid is formed upon contact with water or humid air. Provide adequate ventilation to control exposure
Technical Data
|
Physical Form
|
Red Paste
|
|
Odor
|
Acetic Acid Odor
|
|
Specific Gravity @25oC
|
1.03
|
|
Solubility in Water
|
None
|
|
Boiling Point
|
N/A
|
|
% Volatiles by Volume
|
N/A
|
|
Chemical Stability
|
Stable
|
|
Flash Point
|
N/A- Solid
|
|
Ignitable
|
N/A
|
|
Corrosive
|
N/A
|
|
Reactive
|
N/A
|
|
Extension Rate: (3.18 mm orifice)
|
400 GI min
|
|
Tack Free Time: 25oC (77oF)
|
10-20 minutes
|
|
Cure Time: 25oC (77oF)
|
24 hours
|
|
